Owon TDS Series Bedienungsanleitung PDF herunterladen (Seite 51)

5.Advanced User Guidebook

●Calibrate

Press the Utility button and select Calibrate in the left menu.

The description of Calibrate Menu is shown as the follows:

Do Self-Calibration

The self-calibration procedure can improve the accuracy of the oscilloscope under

the ambient temperature to the greatest extent. If the change of the ambient

temperature is up to or exceeds 5℃, the self-calibration procedure should be

executed to obtain the highest level of accuracy.

Before performing a self-calibration, disconnect all probes or wires from the input

connector. Press the "Utility" button, select Calibrate in the left menu, select Self

Calibrate in the bottom menu. A confirmation window will pop up, select OK after

everything is ready.

●Pass/Fail

The Pass/Fail function monitors changes of signals and output pass or fail signals by

comparing the input signal that is within the pre-defined mask.

Press the Utility button and select Pass/Fail in the left menu.

Function Menu

Setting

Description

BackLight 0%~99%

Drag the slider or turn the G knob to adjust

the backlight.

Graticule

Select the grid type

Menu Display

5s~50s, Infinite

Set the disappear time of left and right menu

Gesture

ON, OFF

Enable/disable the touchscreen controls

Function Menu

Description

Self Calibrate

Carry out the self-calibration procedure.

Factory Set

Call out the factory settings.

Touch Screen Calibrate

Touchscreen accuracy calibration

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 81 82

Keine Kommentare

Owon TDS Series Bedienungsanleitung Seite 51