Owon AG1022 Bedienungsanleitung PDF herunterladen (Seite 17)

5.Front Panel Operation

To set signals

The following describes how to set and output Sine, Square, Ramp, Pulse, Noise, Arbitrary

signals and DC.

To Output Sine Signals

Press button to call the user interface of Sine signal, the Sine waveform

parameters can be set by operating the Sine setting menu on the right.

The parameters of Sine waveform are: Frequency/Period, Amplitude/High Level,

Offset/Low Level. You can operate the menu by using the menu selection buttons on the

right.

Channel

Setting menu

of Sine signal

Amplitude

Load

Offset

Current signal

Frequency

Parameter 3

Parameter 2

Parameter 1

Sine

Figure 5-2: The User Interface of Sine Signal

To Set the Frequency/Period

Press F1 button, the chosen menu item is highlighted, the focused parameter is

displayed in Parameter 1. Press F1 button to switch between Frequency/Period.

Two methods to change the chosen parameter:

 Turn the knob to change the value of cursor position. Press / direction key to

move the cursor.

 Press a number key in the front panel, an input box will pop up; keep going to input

the value. Press direction key to delete the last number. Press F1 ～ F3 to

choose the unit, or press F4 to go to next page and choose other units. Press

F5 to cancel the input.

AG1022：The frequency range is 1μHz～25MHz; the period range is 40ns～1Ms.

AG1012：The frequency range is 1μHz～10MHz; the period range is 100ns～1Ms.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 40 41

Keine Kommentare

Owon AG1022 Bedienungsanleitung Seite 17