Owon AG1022 Bedienungsanleitung PDF herunterladen (Seite 36)

7.SCPI

7. SCPI

The waveform generator supports SCPI, and the users can operate and control the device by USB and

COM interface. For detailed information about SCPI please refer to

《AG Series Waveform

Generator SCPI Protocol》.

8. Troubleshooting

1. The instrument is powered on but no Display.

 Check if the power is connected properly.

 Check if the Power Switch is in the proper voltage scale.

 Check if the fuse which is below the AC Power socket is used appropriately and

in good condition (the cover can be pried open with a straight screwdriver).

 Restart the instrument after the steps above.

 If the problem still exists, please contact Lilliput for our service.

2. The measured value of output signal amplitude disaccords to the displayed value:

Check if the actual load matches the set one. Please refer to "To Set the Output Load"

on P27.

If you encounter other problems, try to reset the settings (refer to "To Return to Default

Setting" on P27) or restart the instrument. If it still can not work properly, please contact

Lilliput for our service.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41

Keine Kommentare

Owon AG1022 Bedienungsanleitung Seite 36