Owon AG1022 Bedienungsanleitung PDF herunterladen (Seite 18)

5.Front Panel Operation

Figure 5-3: Set the frequency using number keys

To Set the Amplitude

Press F2 , confirm whether the "Ampl" menu item is highlighted; if not, press F2 to

switch into "Ampl". In Parameter 2, a cursor appears under the value of amplitude. Use

the knob or the number keys to set the desired value.

To Set the Offset

Press F3 , confirm whether the "Offset" menu item is highlighted; if not, press F3

to switch into "Offset". In Parameter 3, a cursor appears under the value of offset. Use

the knob or the number keys to set the desired value.

To Set the High Level

Press F2 , confirm whether the "Hi_Level" menu item is highlighted; if not, press

F2 to switch into "Hi_Level". In Parameter 2, a cursor appears under the value of

amplitude. Use the knob or the number keys to set the desired value.

To Set the Low Level

Press F3 , confirm whether the "Lo_Level" menu item is highlighted; if not, press

F3 to switch into "Lo_Level". In Parameter 3, a cursor appears under the value of

offset. Use the knob or the number keys to set the desired value.

To Output Square Signals

Press button to call the user interface of Square signal, the Square waveform

parameters can be set by operating the Square setting menu on the right.

The parameters of Square waveform are: Frequency/Period, Amplitude/High Level,

Offset/Low Level, Duty. You can operate the menu by using the menu selection buttons

on the right.

To set the Frequency/Period, Amplitude/High Level, Offset/Low Level, please refer to "To

Output Sine Signals" on P12.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 40 41

Keine Kommentare

Owon AG1022 Bedienungsanleitung Seite 18